Phase 2 of the arms has begun!!!
The painters tape pealed some of the white paint when I took it off so I had to do some touch ups but decided to paint in the red lines first.
Now to let it sit and dry before I put a second coat of white and red:
Second coat finished and looking good!
I’m going to let the painted arms sit for a few hours before I spray the gloss over it and start assembling.
I decided that I am not doing the elbow because it’s going to be hard enough to move in this armor.
Now, to do the left arm while the paint sits.
The foam was all heated by my Heat gun and then molded to the size that I wanted.
The shoulder blades are done and glued together:
Glued the elastic straps:
The upper arm is done:
The lower arm was difficult but I figured it out. I heated the whole foam so I could bend to to an extreme:
I glued the wrist part together and then attached elastic to make sure it stays together. Then attached a small piece of elastic at the end to hold.
I heated the second part of the lower arm so it would mold perfectly on the base and glued it together.
How does it look????
Full body shot! (Yes, I am wearing a Halo 3 shirt!!! Hee hee)
The right arm will probably be done tomorrow. I am going to start drawing the leg parts now.
I am also going to start the drawings for the gloves. The gloves are going to be easy so I’m not stressed about that so I will probably do that last.
I am also going to attach the logo tomorrow.
Let me know if you have questions!