Ok! I got really ambitious tonight and thought I would start working on the back of the armor.

I needed to draw out the shoulder blade parts of the armor (That will hold the lights). I know that they are smaller in the game but I needed enough room to work with the wiring.

Because the back is going to have so many parts and very intricate; instead of, attaching the pieces rights away, I mapped it out with the drawings.

I drew up the middle part of the back to for sizing really. I am probably going to redraw later because I have to add a small light within the design.

Now to cut out the shoulder blades:

I needed to poke through so holes to what I did was use a pin so it would make small holes so I could reorganize them more easier in case I needed to add more or take out lights.

After I decided where the holes go, I used the soldering tool to make the holes larger so I could push the lights through.

I pushed the lights through the shoulder blade:

I just placed the blades where they will have to go and have not attached yet because I have a lot more to do.

And now the lights:

I have so much to do but this is a great start to July!

Let me know if anyone has any questions!!!!